40 AWG wire Stripping and Manipulation

Mike,
it seems to me like there is a stripper material that you can use. How fast a stripping process do you need it to be?

Mike,

If you do a google search for polyimide stripper you will find lots of options ; one or more should work.

rb

Since I have some time on my hands these days, I found the following. Polyimide is used on fiber optic filament as well as wire and the sizes are quite small. Below are some links to ways to strip the coating off the fiber. Some are are fiber optic filament but should work for copper wire. I have also shown the old formula using NMP. I believe if time is not essential, you can place a sample in the NMP, let sit, and when you remove from the NMP pull the wet end of the sample through a gauze or cheese cloth pad. If not adequately removed, soak some more and repeat process. Once enough is removed, dip in deionized water to remove any NMP and dry.

"NMP IS A VERY STRONG SOLVENT SO USE SAFE LAB PRACTICES TO AVOID INJURY!!!"

richard


www.fiberlogix.com/Polyimide%20Fiber%20stripper.html
www.dynaloy.com/Products/other_microelectronics.html
mtcusa.sslcert19.com/catalog/index.asp?pgName=42
www.fujifilm-ffem.com/downloads/QZ3322_US09.pdf


Wet Strip Process:
The following is a typical procedure for removing
soft baked, photocross-linked polyimide.
1. NMP at 85°C for 5 minutes
2. QZ3322 polyimide stripper at 70°C for 5 minutes
3. NMP at room temperature for 5 minutes
4. DI water rinse, dry completely


(Note: NMP is N-Methylpyrrolidone solvent.