How to resolve AdBlock issue? × Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.
Bending test for high carbon steel wire
- Archived Forum Admin
-
Topic Author - Offline
- Platnium Boarder
-
Less More
12 years 10 months ago #1043 by Archived Forum Admin
Bending test for high carbon steel wire was created by Archived Forum Admin
Dear All,
I have some problems on bending test of steel wire.when I checked torsion number, tensile strenght and wrapping test, everything is okey but on bending test # of bending is about 5-7. It should be more than 15. Please help me about how to increase # of bending without decreasing tensile strenght and etc.
and what is the reasons for low bending cycle.
Best regards.,
Murat
Murat
I have some problems on bending test of steel wire.when I checked torsion number, tensile strenght and wrapping test, everything is okey but on bending test # of bending is about 5-7. It should be more than 15. Please help me about how to increase # of bending without decreasing tensile strenght and etc.
and what is the reasons for low bending cycle.
Best regards.,
Murat
Murat
Please Log in to join the conversation.
- Archived Forum Admin
- Topic Author
- Offline
- Platnium Boarder
-
12 years 10 months ago #1044 by Archived Forum Admin
Replied by Archived Forum Admin on topic Re: Bending test for high carbon steel wire
Please give diameter and carbon content of wire to be tested.
In general, specifications call, as ductility indicator, for bend test or torsion test depending on the size of the wire, usually, do not call for both. Larger diameters are complicated to torsion test.
Eduardo Anaya
Senior Consultant
INDEPA S.C.
Mexico City
Tel(011-52)555-407-7451
This email address is being protected from spambots. You need JavaScript enabled to view it.
In general, specifications call, as ductility indicator, for bend test or torsion test depending on the size of the wire, usually, do not call for both. Larger diameters are complicated to torsion test.
Eduardo Anaya
Senior Consultant
INDEPA S.C.
Mexico City
Tel(011-52)555-407-7451
This email address is being protected from spambots. You need JavaScript enabled to view it.
Please Log in to join the conversation.
- Archived Forum Admin
- Topic Author
- Offline
- Platnium Boarder
-
12 years 10 months ago #1045 by Archived Forum Admin
Replied by Archived Forum Admin on topic Re: Bending test for high carbon steel wire
carbon content 0,75
diameter 2,00-3,00 mm
best regards.
Murat
diameter 2,00-3,00 mm
best regards.
Murat
Please Log in to join the conversation.
Moderators: Peter J Stewart-Hay, Eduardo Anaya, Peter M Power
Time to create page: 0.092 seconds