- Posts: 1
- Thank you received: 0
×
Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.
Drawing Die Angles
- Jeff Christensen
- Topic Author
- Offline
- Fresh Boarder
Less
More
11 years 4 months ago #2638
by Jeff Christensen
Drawing Die Angles was created by Jeff Christensen
In what situations does it make sense to increase (or decrease) the drawing angle?
Please Log in to join the conversation.
- Eduardo Anaya
- Offline
- Moderator
Less
More
- Posts: 15
- Thank you received: 2
11 years 4 months ago #2639
by Eduardo Anaya
Replied by Eduardo Anaya on topic Re: Drawing Die Angles
The drawing angle is affected by
1.-The reduction of area the die is performing ,
2.-The coating of the wire, if it is bright , galvanized or copper coated
3.-Drawing Speeds
4.-Type of lubricant use
1.-The reduction of area the die is performing ,
2.-The coating of the wire, if it is bright , galvanized or copper coated
3.-Drawing Speeds
4.-Type of lubricant use
The following user(s) said Thank You: vinay Bansal
Please Log in to join the conversation.
- Peter M Power
- Offline
- Moderator
Less
More
- Posts: 2
- Thank you received: 0
9 years 11 months ago #2835
by Peter M Power
Replied by Peter M Power on topic Re: Drawing Die Angles
In addition to the previous reply, it is very important to utilize the delta parameter calculation to guide the selection of die angle to fit the reduction in order to avoid the problems associated with a poor delta.
Please Log in to join the conversation.
- vinay Bansal
- Visitor
4 years 9 months ago #3090
by vinay Bansal
Replied by vinay Bansal on topic Drawing Die Angles
What shoul be angel of a bar drawing dieJeff Christensen wrote: In what situations does it make sense to increase (or decrease) the drawing angle?
Please Log in to join the conversation.
- vinay Bansal
- Visitor
4 years 9 months ago #3091
by vinay Bansal
Replied by vinay Bansal on topic Drawing Die Angles
What is delta in die
Please Log in to join the conversation.
- vinay Bansal
- Visitor
4 years 9 months ago #3092
by vinay Bansal
Replied by vinay Bansal on topic Drawing Die Angles
What is delta in drawing die
Please Log in to join the conversation.
Moderators: Peter J Stewart-Hay, Eduardo Anaya, Peter M Power
Time to create page: 0.069 seconds