How to resolve AdBlock issue? 
- Posts: 1
- Thank you received: 0
× Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.
Drawing Die Angles
- Jeff Christensen
- Topic Author
- Offline
- Fresh Boarder
-
Less More
11 years 2 months ago #2638 by Jeff Christensen
Drawing Die Angles was created by Jeff Christensen
In what situations does it make sense to increase (or decrease) the drawing angle?
Please Log in to join the conversation.
- Eduardo Anaya
- Offline
- Moderator
-
Less More
- Posts: 15
- Thank you received: 2
11 years 2 months ago #2639 by Eduardo Anaya
Replied by Eduardo Anaya on topic Re: Drawing Die Angles
The drawing angle is affected by
1.-The reduction of area the die is performing ,
2.-The coating of the wire, if it is bright , galvanized or copper coated
3.-Drawing Speeds
4.-Type of lubricant use
1.-The reduction of area the die is performing ,
2.-The coating of the wire, if it is bright , galvanized or copper coated
3.-Drawing Speeds
4.-Type of lubricant use
The following user(s) said Thank You: vinay Bansal
Please Log in to join the conversation.
- Peter M Power
- Offline
- Moderator
-
Less More
- Posts: 2
- Thank you received: 0
9 years 9 months ago #2835 by Peter M Power
Replied by Peter M Power on topic Re: Drawing Die Angles
In addition to the previous reply, it is very important to utilize the delta parameter calculation to guide the selection of die angle to fit the reduction in order to avoid the problems associated with a poor delta.
Please Log in to join the conversation.
- vinay Bansal
- Visitor
-
4 years 7 months ago #3090 by vinay Bansal
Replied by vinay Bansal on topic Drawing Die Angles
What shoul be angel of a bar drawing dieJeff Christensen wrote: In what situations does it make sense to increase (or decrease) the drawing angle?
Please Log in to join the conversation.
- vinay Bansal
- Visitor
-
4 years 7 months ago #3091 by vinay Bansal
Replied by vinay Bansal on topic Drawing Die Angles
What is delta in die
Please Log in to join the conversation.
- vinay Bansal
- Visitor
-
4 years 7 months ago #3092 by vinay Bansal
Replied by vinay Bansal on topic Drawing Die Angles
What is delta in drawing die
Please Log in to join the conversation.
Moderators: Peter J Stewart-Hay, Eduardo Anaya, Peter M Power
Time to create page: 0.106 seconds