How to resolve AdBlock issue? × Have a question on lubricants, wire drawing, quality, testing, ISO, environmental? Post your question here to get the answer!
Plastic wire ties
- Archived Forum Admin
-
Topic Author - Offline
- Platnium Boarder
-
Less More
11 years 10 months ago #2209 by Archived Forum Admin
Plastic wire ties was created by Archived Forum Admin
I am looking for a supplier for the wire tie that fits through a hole in the reel flange to secure the end of the wire conductor.
Any suggestions?
Thanks
Any suggestions?
Thanks
Please Log in to join the conversation.
- Archived Forum Admin
- Topic Author
- Offline
- Platnium Boarder
-
11 years 10 months ago #2210 by Archived Forum Admin
Replied by Archived Forum Admin on topic Re: Plastic wire ties
Hello again wirenut4sure,
Could you please describe these plastic wire ties in more detail? How do they connect to the reel? Adhesive? How do they connect to the wire? Spring Clip? Presumably the wire does not make it through the hole on the reel flange but how is that guaranteed and how does the wire stay tightly wound?
Thank you,
Regards,
Peter J. Stewart-Hay P. Eng.
Principal
Stewart-Hay Associates
www.Stewart-Hay.com
Could you please describe these plastic wire ties in more detail? How do they connect to the reel? Adhesive? How do they connect to the wire? Spring Clip? Presumably the wire does not make it through the hole on the reel flange but how is that guaranteed and how does the wire stay tightly wound?
Thank you,
Regards,
Peter J. Stewart-Hay P. Eng.
Principal
Stewart-Hay Associates
www.Stewart-Hay.com
Please Log in to join the conversation.
- David Ferraro
- Offline
- Fresh Boarder
-
Less More
- Posts: 1
- Thank you received: 0
11 years 8 months ago #2495 by David Ferraro
Replied by David Ferraro on topic Re: Plastic wire ties
See if this is what you need
carris.com/product/35/wire-ties
If it is - call Carris Reels Virginia 802 770 3641 and ask for Tammy
carris.com/product/35/wire-ties
If it is - call Carris Reels Virginia 802 770 3641 and ask for Tammy
Please Log in to join the conversation.
Moderators: Erik A Macs, Peter J Stewart-Hay
Time to create page: 0.083 seconds